Collins USA, LLC

Winsted Tools


Woodworking with Will Myers


The Hardware Cabinet - part 2 by Will Myers

6 of 12  

Assemble the four case sides first. Glue and nail the corner rabbet joints and check square.

Starting at the top divider, spread a bit of glue in the dado and slide the divider in.

Once in place, drive a couple of small wire nails thru the divider at an angle into the case side and then use a nail set to drive it flush.

Repeat until all the dividers are in place, once again, check to make sure the case is still square and true. If it is not use a clamps to pull it back into alignment.

In the next installment, we will finish up the case and start on the drawers!

Very Best,

Will Myers
March 2017
Questions, comments?

Learn how. Discover why. Build better.
6 of 12  
Building the Portable Moravian Workbench with Will Myers (DVD)
Building the Portable Moravian Workbench with Will Myers (DVD)


Buy this two-disc DVD set now and build an 18th-century workbench with techniques for woodworkers of any skill level. [Read More]
Buy Now

Moulding Planes



Copyright 2005-2018, and Wiktor Kuc.  All Rights Reserved.  Designated trademarks and brands are the property of their respective owners.
No part of the content from this website can be reproduced by any means without specific permission of the publisher.
Valid CSS!